气相输运沉积制备c轴择优取向的碘化铋薄膜

铋基卤化物材料因其无毒和优良的光电性能而显示出巨大的应用潜力。BiI₃作为一种层状重金属半导体,已被用于X射线检测、γ射线检测和压力传感器等领域,最近其作为一种薄膜太阳能电池吸收材料备受关注。本文采用简单的气相输运沉积(VTD)法,以BiI₃晶体粉末作为蒸发源,在玻璃基底上得到高质量c轴择优取向的BiI₃薄膜。并通过研究蒸发源温度和沉积距离对薄膜物相和形貌的影响,分析了BiI₃薄膜择优生长的机理。结果表明VTD法制备的BiI₃薄膜属于三斜晶系,其光学带隙为~1.8 eV。沉积温度对薄膜的择优取向有较大影响,在沉积温度低于270 ℃时,沉积的薄膜具有沿c轴择优取向生长的特点,超过此温度,c轴择优取向生长消失。在衬底温度为250 ℃、沉积距离为15 cm时制备的薄膜结晶性能最好,晶体形貌为片状八面体。     

雾化辅助化学气相沉积法氧化镓薄膜生长研究

采用自主设计搭建的雾化辅助化学气相沉积系统设备,开展了Ga₂O₃薄膜制备及其特性研究工作。通过X射线衍射研究了沉积温度、系统沉积压差对Ga₂O₃薄膜结晶质量的影响。结果表明,Ga₂O₃在425~650 ℃温度区间存在物相转换关系。随着沉积温度从425 ℃升高至650 ℃,薄膜结晶分别由非晶态、纯α-Ga₂O₃结晶状态向α-Ga₂O₃、β-Ga₂O₃两相混合结晶状态改变。通过原子力显微镜表征探究了生长温度对Ga₂O₃薄膜表面形貌的影响,从475 ℃升高至650 ℃时,薄膜表面粗糙度由26.8 nm下降至24.8 nm。同时,高分辨X射线衍射仪测试表明475 ℃、5 Pa压差条件下的α-Ga₂O₃薄膜样品半峰全宽仅为190.8″,为高度结晶态的单晶α-Ga₂O₃薄膜材料。     

Facile Synthesis of Manganese Tellurite Nanoparticles for Magnetic Resonance Imaging-Guided Photothermal Therapy

In this study, manganese tellurite (MnTeO₃) nanoparticles are developed as theranostic agents for magnetic resonance imaging (MRI)-guided photothermal therapy of tumor. MnTeO₃ nanoparticles are synthesized via a simple one-step method. The as-synthesized MnTeO₃ nanoparticles with uniform size show good biocompatibility. In particular, MnTeO₃ nanoparticles exhibit a high photothermal conversion efficiency (η = 26.3%), which is higher than that of gold nanorods. Moreover, MnTeO₃ nanoparticles also have high MRI performance. The longitudinal relaxivity (r₁) value of MnTeO₃ nanoparticles is determined to be 8.08 ± 0.2 mm ⁻¹ s⁻¹, which is higher than that of clinically approved T₁-contrast agents Gd-DTPA (4.49 ± 0.1 mm ⁻¹ s⁻¹). The subsequent MnTeO₃ nanoparticles-mediated photothermal therapy displays a highly efficient ablation of tumor cells both in vitro and in vivo with negligible toxicity. It is demonstrated that MnTeO₃ nanoparticles can serve as promising theranostic agents with great potentials for MRI-guided photothermal therapy.     

3.0T MRI检查结合X线钼靶诊断乳腺恶性肿瘤的研究

本研究探讨3.0T磁共振成像(MRI)结合X线钼靶诊断乳腺恶性肿瘤的价值。采用回顾性研究方法,选取乳腺肿块患者110例162个病灶,给予3.0T MRI及X线钼靶检查。经病理确诊为恶性病变101个;恶性病灶形态不规则、边缘毛刺、时间-信号强度曲线(TIC)类型Ⅲ型和早期增强率≥60%比例明显高于良性病灶(P<0.05),而分叶状比例和表观扩散系数(ADC)值明显低于良性病变(P<0.05);恶性病变X线钼靶表现:形态不规则、钙化、结构不对称和大导管征比例明显高于良性病变(P<0.05);MRI联合X线钼靶诊断乳腺恶性病变的灵敏性、准确性和阴性预测值明显高于MRI诊断(P<0.05)。3.0T MRI检查结合X线钼靶诊断乳腺恶性肿瘤有较好的价值。     

Air-Stable Hexagonal Bipyramidal Dysprosium(III) Single-Ion Magnets with Nearly Perfect D6h Local Symmetry

Eight-coordinated Dy^III centres with D_6h symmetry are expected to act as high-performance single-molecule magnets (SMMs) due to the simultaneous fulfilment of magnetic axiality and a high coordination number (a requisite for air stability). But the experimental realization is challenging due to the requirement of six coordinating atoms in the equatorial plane of the hexagonal bipyramid; this is usually too crowded for the central Dy^III ion. Here a hexaaza macrocyclic Schiff base ligand and finetuned axial alkoxide/phenol-type ligands are used to show that a family of hexagonal bipyramidal Dy^III complexes can be isolated. Among them, three complexes possess nearly perfect D_6h local symmetry. The highest effective magnetic reversal barrier is found at 1338(3) K and an open hysteresis temperature of 6 K at the field sweeping rate of 1.2 mT s⁻¹; this represents a new record for D_6h SMMs.     

Magnetic properties of a polyfluorene derivative containing complexed neodymium ions

Poly[9,9′‐dihexylfluorene‐2,7‐diyl)‐6,6″‐(2,2′:6′,2″‐terpyridine)] (LaPPS75) and its complexes with neodymium were synthesized and characterized. Magnetic measurements showed that the noncomplexed polymer presented a ferromagnetic contribution due to the formation of π stacking, and that in absence of those, the ferromagnetic behavior is suppressed. The pristine polymer, the complexed one and a low‐molecular‐weight model compound with the same structure of the complexed site in the parent polymer were studied. The observed behavior found is presented and discussed, the most important finding was that when a conjugated chain is used as a host for the metallic ion, an amplification of four times for the magnetization is achieved, using the same metallic content for complexed polymer and model compound for comparison. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 304–311     

One‐Step Labeling of Collagen Hydrogels with Polydopamine and Manganese Porphyrin for Non‐Invasive Scaffold Tracking on Magnetic Resonance Imaging

Biomaterial scaffolds are the cornerstone to supporting 3D tissue growth. Optimized scaffold design is critical to successful regeneration, and this optimization requires accurate knowledge of the scaffold's interaction with living tissue in the dynamic in vivo milieu. Unfortunately, non‐invasive methods that can probe scaffolds in the intact living subject are largely underexplored, with imaging‐based assessment relying on either imaging cells seeded on the scaffold or imaging scaffolds that have been chemically altered. In this work, the authors develop a broadly applicable magnetic resonance imaging (MRI) method to image scaffolds directly. A positive‐contrast “bright” manganese porphyrin (MnP) agent for labeling scaffolds is used to achieve high sensitivity and specificity, and polydopamine, a biologically derived universal adhesive, is employed for adhering the MnP. The technique was optimized in vitro on a prototypic collagen gel, and in vivo assessment was performed in rats. The results demonstrate superior in vivo scaffold visualization and the potential for quantitative tracking of degradation over time. Designed with ease of synthesis in mind and general applicability for the continuing expansion of available biomaterials, the proposed method will allow tissue engineers to assess and fine‐tune the in vivo behavior of their scaffolds for optimal regeneration.     

Improving the gas barrier,mechanical and thermal properties of poly(vinyl alcohol) with molybdenum disulfide nanosheets

New multifunctional materials with both high structural and gas barrier performances are important for a range of applications. Herein we present a one‐step mechanochemical process to prepare molybdenum disulfide (MoS₂) nanosheets with hydroxy functional groups that can simultaneously improve mechanical strength, thermal conductivity, and gas permittivity of a polymer composite. By homogeneously incorporating these functionalized MoS₂ nanosheets at low loading of less than 1 vol %, a poly(vinyl alcohol) (PVA) polymer exhibits elongation at break of 154%, toughness of 82 MJ/m³, and in‐plane thermal conductivity of 2.31 W/m K. Furthermore, this composite exhibits significant gas barrier performance, reducing the permeability of helium by 95%. Under fire condition, the MoS₂ nanosheets form thermally stable char, thus enhancing the material's resistance to fire. Hydrogen bonding has been identified as the main interaction mechanism between the nanofillers and the polymer matrix. The present results suggest that the PVA composite reinforced with 2D layered nanomaterial offers great potentials in packaging and fire retardant applications. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 406–414     

Synthesis,crystal structure and magnetic properties of a new tri‐nuclear iron (II,III) complex,a precursor for the preparation of superparamagnetic Fe3O4 nanoparticles applicable in the removal of Cd2+

This study reports the structural and spectroscopic characterization of a novel metal organic compound formulated as [Fe (bpy)₃] [Fe (dipic)₂]₂.7H₂O ( 1 ) (dipic = pyridine‐2,6‐dicarboxylate and bpy = 2,2^′‐bipyridine). 1 was investigated by elemental analysis, FT‐IR spectroscopy, powder X‐ray diffraction and single crystal X‐ray diffraction (SC‐XRD), which revealed a triclinic structure of expected composition. Thermal degradation of 1 was also investigated. Complex 1 was used as a precursor to prepare superparamagnetic nanoparticles of Fe₃O₄ by thermal analysis. The obtained Fe₃O₄ was characterized by Fourier transformed infrared spectroscopy (FT‐IR), powder X‐ray diffraction (XRD) and scanning electron microscopy (SEM). Fe₃O₄ nanoparticles were used as a nano‐adsorbent to remove Cd²⁺ from water at room temperature. The results showed that this nano‐adsorbent is effective in removing Cd²⁺ from contaminated water sources, and that the maximal effectivity of adsorption occurs at pH = 6. Magnetic measurements of complex 1 and Fe₃O₄ nanoparticles at room temperature revealed paramagnetic and superparamagnetic behavior, respectively.